You will need to put the movie upside down so that it reflects correctly on the wall. Turn your phone on a video or movie, and then set the lock screen. Attach to the foam board in those exact spots. You can push those little prongs onto the piece of black foam board and the magnetic purse closure will indent exactly where you need to place them on the foam board. My husband’s phone doesn’t have built in metal plates, but he has the little metal circles that come with the magnetic car mounts on the inside of his phone case, and the purse magnets worked just fine with those, too.Īttach the purse magnet on the phone case where the metal plate is and allow the prongs to stick out. My phone case has built in metal plates to use with a magnetic car mount, so I just needed the magnet side of the purse magnetic closure stuck to my phone case (I added 2). I used the magnetic side of two purse magnetic closures. Some people I’ve seen use double-sided tape, but I wanted something that didn’t actually leave a residue. This shelf allows you to move your phone forward and backward in the shoe box in order to focus the screen. Cut one piece to be the base and one piece to be the shelf and hot glue them together. Next, measure the width and height of the inside of the shoe box and use those measurements to make a small shelf to hold your smartphone with the black foam board. Hold it there for a few seconds while it hardens. Next, liberally apply hot glue around the magnifying glass and place it into the circle. Now if your box has a lid that comes down past where you cut the hole out, Use the cut out from the shoe box to measure how much of the lid you need to cut off. Then, use the magnifying glass to draw a circle around the end of the shoe box. Then, you’re going to take a hack saw and saw off the handle as close to the rounded part as you can. The largest I could find was about 3 1/2 inches or so. I recommend finding a large round magnifying glass.
0 Comments
Leave a Reply. |